replacement of sand by marble powder in concrete  search results

replacement of sand by marble powder in concrete search results

Experimental Study on Partial replacement of sand with ...

to partial replacement of the fine aggregate with marble powder. M25 of concrete mix has been taken and casted into cubes and astrength tests have been conducted. In this paper I conduct an experiment on partial replacement of sand with marble dust powder at different % of mdp which are 20,25,30,35,40%.

More

Use of Waste Marble Powder as Partial Replacement in ...

May 18, 2015  It can be observed that the flexure strength for the concrete mix containing 10% of marble powder dust in cement got increased by the value of 9.2% and for 10% replacement with sand the flexure strength also got increased about 9.3% but it decreased when the mix contains 20% marble powder dust against cement (10%) and sand(10%) about 10%.

More

UTILIZATION OF WASTE QUARRY DUST AND MARBLE POWDER IN CONCRETE

The research focuses on the effect of using waste marble powder and quarry dust as partial sand replacement materials on concrete properties. Massive exploitation of the nonrenewable natural resources to fulfill the aggregate requirement of billions

More

Cement Replacement in concrete with Marble Dust Powder

of concrete is increased by replacement of cement with marble dust powder up to 10%, and after than adding extra percentage of marble dust powder by replacement of cement, the compressive strength of concrete is start to decrease. According to this study, the replacement of cement up to 10% with marble dust powder in M-20 grade

More

The effect of the using waste marble dust as fine sand on ...

It was proved that the behavior of concrete produced from marble powder found that WMP as sand substitute improved concrete properties when compared to that as cement replacement [21].

More

An Experimental investigation on utilizations of Marble ...

The durability as well as workability has increased to large extent by use of marble dust as replacement of fine aggregate and coarse aggregate. The effect on properties of concrete were investigated and concluded that optimum percentage for replacement of sand with marble powder in concrete

More

Experimental study on the behavior of waste marble powder ...

Aug 25, 2020  In a research study carried out by Hebhoub et al. , three sequences of concrete mixtures were prepared with waste marble aggregates as a sand replacement, coarse aggregate replacement, and both fine and coarse aggregates replaced in mixtures. In their study, 50% sand replacement mixtures showed 23.65% gain in compressive strength at 28 days as ...

More

Experimental Utilization of Marble Dust Powder as Partial ...

Aliabdoet.al. [12], studied the replacement of cement or sand by marble powder for improvement in concrete properties. It shows that sand replacement gives better results as compare to cement replacement. Also, AlirezaNaji et al. [9], studied that average particle size of rice husk provides positive effect on compressive

More

Utilization of alternative sand for preparation of ...

Apr 20, 2020  Mortar prepared with marble dust as replacement to natural sand shows marginal change in the water absorption capacity (Buyuksagis et al., 2017) whereas granite powder inclusion reduces the water absorption value by 6.6% and 6.1% for 30% and 40% percent replacement respectively (Gupta and Vyas, 2018). This decrement in value due to granite ...

More

PARTIAL REPLACEMENT OF FINE AGGREGATE BY MARBLE

of marble powder the compressive strength gradually de-creases. b) Compressive strength of 5% marble powder partially re-placed with fine aggregate at 28 days water curing is c) Partial replacement of fine aggregate with marble powder in a concrete mix boosts the compressive strength of con-crete.

More

Partial Replacement of Cement With Marble Powder in Concrete

Marble powder: The marble dust is obtained from RAK ceramics. The specific gravity of tile dust is found to be 2.62 and the fineness is found to be 7.5%. 3.METHODOLOGY: The evaluation of tile powder which is used as a replacement of cement material begins with the concrete testing.

More

Marble Powder As A Partial Replacement Of Sand - 1454 ...

Marble Powder As A Partial Replacement Of Sand. V. CONCLUSION From the test results it is clearly evident that granite powder as a partial replacement of sand proves to be beneficial when Durability properties of Concrete is considered. Durability of Concrete using Granite Fines is almost same as that of reference mix (GF0), However at 30% ...

More

Experimental Study on Partial replacement of sand with ...

to partial replacement of the fine aggregate with marble powder. M25 of concrete mix has been taken and casted into cubes and astrength tests have been conducted. In this paper I conduct an experiment on partial replacement of sand with marble dust powder at different % of mdp which are 20,25,30,35,40%.

More

Properties of concrete incorporating sand and cement with ...

marble powder as a partial replacement in the cement and sand mix, where MX0 is control mix with no marble powder, MX1 with 10% marble powder as partial replacement of sand, MX2 with 10% marble powder as partial replacement of cement and MX3 with 15% marble powder as partial

More

replacement of sand by marble powder in concrete - BINQ Mining

May 03, 2013  Characterization of Marble Powder for Its – UW-Milwaukee. Sustainable Development of Cement and Concrete, October 5-7, 2005, Toronto, CANADA 10% substitution of sand by the marble powder provided maximum compressive . either cement or sand replacement), and by eventually adding a »More detailed

More

UTILIZATION OF WASTE QUARRY DUST AND MARBLE

incorporating marble powder as partial sand substitute. Corinaldesi et al. (2010), found that at same workability, marble powder showed high strength at 10% sand substitution. This research aims at utilization of waste marble powder and quarry dust in concrete as partial replacement of sand.

More

Partial Replacement of Cement with Marble Dust Powder

Partial Replacement of Cement with Marble Dust Powder. : In this project we have made fly ash cement bricks with variations in its percentage of composition. The project describes the use of local fly ash in construction industry in a way to minimize the industrial waste. The aim of this project is to find that percentage of composition by ...

More

An Experimental investigation on utilizations of Marble ...

The durability as well as workability has increased to large extent by use of marble dust as replacement of fine aggregate and coarse aggregate. The effect on properties of concrete were investigated and concluded that optimum percentage for replacement of sand with marble powder in concrete

More

"Partial Replacement of Cement with Marble Dust Powder"

To avoid adverse environmental circumstances, the content of cement is reduced in concrete and replaced by marble dust which reduces cost and addition of marble dust also increases strength and ...

More

IMPACT OF MARBLE DUST ON CEMENT CONCRETE PROPERTIES

May 05, 2015  The concrete mix proportion for M25 grade was designed in accordance with I.S. code. QUANTITY OF MARBLE POWDER; 5% of cement replaced by marble powder = 400 gm 10% of marble powder = 800 gm Experimental conditions: Compressive strength of concrete was undertaken on 15 cm cubic specimens. at 7 days and 28 days of age.

More

Utilization of alternative sand for preparation of ...

Apr 20, 2020  Mortar prepared with marble dust as replacement to natural sand shows marginal change in the water absorption capacity (Buyuksagis et al., 2017) whereas granite powder inclusion reduces the water absorption value by 6.6% and 6.1% for 30% and 40% percent replacement respectively (Gupta and Vyas, 2018). This decrement in value due to granite ...

More

Can we make concrete using quarry dust as a replacement ...

Answer (1 of 7): Of course. Quite a standard procedure. We call it crusher dust, or manufactured sand. Dependent on the source rock and type of crusher, the particle shape is unlikely to be nice round grains, which makes for concrete that is not quite as nice to play with, but it is still far fr...

More

PARTIAL REPLACEMENT OF FINE AGGREGATE BY MARBLE

of marble powder the compressive strength gradually de-creases. b) Compressive strength of 5% marble powder partially re-placed with fine aggregate at 28 days water curing is c) Partial replacement of fine aggregate with marble powder in a concrete mix boosts the compressive strength of con-crete.

More

Research Paper PARTIAL REPLACEMENT OF CEMENT WITH

Table 3: Sand Marble powder: Marble powder was collected from the dressing and processing unit in Jalgaon. It was initially in wet form (i.e. slurry); after that it is dried by exposing in the sun and finally sieved by IS-90 micron sieve before mixing in concrete.

More

Properties of concrete incorporating sand and cement with ...

marble powder as a partial replacement in the cement and sand mix, where MX0 is control mix with no marble powder, MX1 with 10% marble powder as partial replacement of sand, MX2 with 10% marble powder as partial replacement of cement and MX3 with 15% marble powder as partial

More

UTILIZATION OF WASTE QUARRY DUST AND MARBLE

incorporating marble powder as partial sand substitute. Corinaldesi et al. (2010), found that at same workability, marble powder showed high strength at 10% sand substitution. This research aims at utilization of waste marble powder and quarry dust in concrete as partial replacement of sand.

More

replacement of sand by marble powder in concrete - BINQ Mining

May 03, 2013  Characterization of Marble Powder for Its – UW-Milwaukee. Sustainable Development of Cement and Concrete, October 5-7, 2005, Toronto, CANADA 10% substitution of sand by the marble powder provided maximum compressive . either cement or sand replacement), and by eventually adding a »More detailed

More

Partial Replacement of Cement with Marble Dust Powder

Partial Replacement of Cement with Marble Dust Powder. : In this project we have made fly ash cement bricks with variations in its percentage of composition. The project describes the use of local fly ash in construction industry in a way to minimize the industrial waste. The aim of this project is to find that percentage of composition by ...

More

Mechanical and durability characteristics of marble-powder ...

marble powder as partial replacement in cement con-crete. They used 10% marble powder as replacement for cement and reported that increase in marble powder would signi cantly decrease the workability of concrete. Replacement of cement and sand with marble powder at 10% has been found to improve the mechanical and durability characteristics of ...

More

Investigation on Strength Properties of Concrete with ...

3.5 Marble Powder The specific gravity of marble is 2.577. Local available marble powder used as partial replacement of fine aggregate in concrete. 3.6 Granite Powder Granite belongs to igneous rock family. Granite powder obtained from the polishing units and the properties were found.

More

EXPERIMENTAL INVESTIGATION OF PARTIAL

Shirule et al: studied the ―Partial Replacement of cement with Marble Dust Powder‖. It can be concluded that for M20 grade concrete The Compressive strength of Cubes are increased with addition of waste marble powder up to 10% replace by weight of cement and further any addition of waste marble powder the compressive strength decreases.

More

IMPACT OF MARBLE DUST ON CEMENT CONCRETE PROPERTIES

May 05, 2015  The concrete mix proportion for M25 grade was designed in accordance with I.S. code. QUANTITY OF MARBLE POWDER; 5% of cement replaced by marble powder = 400 gm 10% of marble powder = 800 gm Experimental conditions: Compressive strength of concrete was undertaken on 15 cm cubic specimens. at 7 days and 28 days of age.

More

Utilization of alternative sand for preparation of ...

Apr 20, 2020  Mortar prepared with marble dust as replacement to natural sand shows marginal change in the water absorption capacity (Buyuksagis et al., 2017) whereas granite powder inclusion reduces the water absorption value by 6.6% and 6.1% for 30% and 40% percent replacement respectively (Gupta and Vyas, 2018). This decrement in value due to granite ...

More

Can we make concrete using quarry dust as a replacement ...

Answer (1 of 7): Of course. Quite a standard procedure. We call it crusher dust, or manufactured sand. Dependent on the source rock and type of crusher, the particle shape is unlikely to be nice round grains, which makes for concrete that is not quite as nice to play with, but it is still far fr...

More

Review on the feasibility of Marble Dust as Replacement of ...

fine aggregate replacing natural sand in concrete. The replacement is done partially and fully in the proportion 0%, 25%, 50% and 100% and its effect on concrete properties were analyzed and outcomes that replacement of 50% of sand with marble powder is optimum percentage in concrete. Ronak Malpani et.al (2014) experimentally studied the ...

More

Effects of Incorporation of Marble Powder Obtained by ...

Marble has been commonly used as a building material since ancient times. The disposal of waste materials from the marble industry, consisting of sludge that is composed of powder mixed with water, is one of the current worldwide environmental problems. This experimental study aims to valorize marble powder, which is achieved by grinding the sludge as filler added to the cementitious matrix of ...

More